The Different Reading Modes; Trigger Mode (Default Setting); Aiming Mode - Baracoda D-Fly User Manual

Data capture for workforce in motion

Hide thumbs Also See for D-Fly:

Table of Contents

4.4.

The different reading modes

D-Fly/D-Fly2 has two (2) reading modes. These modes can be changed through both the BaracodaManager

software and the Programming Guide.

4.4.1.

Simply press the trigger when you want to scan a barcode.

Via Bluetooth, a command can be sent to the scanner in order to emulate a press on the trigger to scan a

barcode (see remote trigger cmd in communication protocol document)

4.4.2.

The Aiming mode has been developed for users who need to scan barcodes very close one to another and need

to avoid reading a wrong code. Once in this mode, in order to read a barcode user will have to press the trigger

twice. Pressing it the first time will switch on the beam but will not switch on the decoder (thus allowing user to

aim at the correct barcode) while pressing the trigger the second time will activate the decoder thus allowing

the D-Fly/D-Fly2 to actually decode the barcode.

Option: D-Fly/D-Fly2 allows the "No duplicate scans" feature activation. It avoids user to scan consecutively

twice in the same barcode. By default, this option is disabled, but can be changed through both

BaracodaManager software or Programming Guide.

Baracoda D-Fly & D-Fly2– User Guide v2.4

Data Capture

for Workforce

in Motion

- 9 -

Table of Contents

D-fly2