This document is to be used with BC / BL / BLR 2604
2604
Baracoda, Inc. (US Office)
45 Main street - Suite 616 - Brooklyn, NY 11201
Ph: 718 488 9600 - Fx: 718 488 9601
The bluetooth name and Bluetooth registered trademarks are owned by Bluetooth SIG, Inc., and are used by Baracoda under license. The Baracoda names and Baracoda trademarks are
1 Introduction The 2604 is easy to use. Simply press the trigger to scan a barcode. The colour of the LED indicates the status of the device. A beep indicates when the scanner connects to the remote device and when a barcode is scanned successfully.
1- Make sure that your host device (PC or PDA) is bluetooth enabled. If not, please contact your reseller. 2- Install the BaracodaManager. (update can be downloaded from http://www.baracoda.com/download. ) Make sure that your Bluetooth software is compatible with BaracodaManager.
Simply press the trigger when you want to scan a barcode. 6.2.2 Autoscan mode This mode enables you to scan continuously. By using the cradle, the 2604 can be used as a “presentation” scanner while it is recharging. In autoscan mode, the scan beam is continuously on.
You can configure prefix/suffix through both BaracodaManager and programming guide. There is no prefix/suffix in default settings 6.4.3 Baracoda Header It is a proprietary data encapsulation. It is necessary to activate the Baracoda header in 2 cases: • to use the Baracoda keyboard emulation (KEmul) and Hyper terminal •...
• How to recharge the battery: Plug the cradle connector into the AC wall adapter, then place the 2604 in the cradle. When the scanner is inserted into the cradle and charging, the LED is red (solid). When the scanner is fully charged, the LED will become a solid green.