Transit Safety - Sunrise Medical Jay J3 Owner's Manual

Back
Hide thumbs Also See for Jay J3:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 4
EngLIsh
Back TransIT saFeTy
The J3 back has been dynamically tested for use in a motor
vehicle. Please follow all installation, use and maintenance
instructions within this manual as well as the transit instruc-
tions listed below.
InstructIons
1. If possible and feasible, the rider should transfer to
the original Equipment manufacturer vehicle seat
and use the vehicle restraint.
2. the distance between the top of the user's shoulder
and the top of the back should not exceed 6.5" (16.5
cm).
3. the wheelchair must be labeled as appropriate for
use as a seat in a motor vehicle, dynamically tested
to the performance requirements of Iso standard
7176-19 and installed, used and maintained accord-
ing to the manufacturer's instructions.
4. If the original wheelchair seat was replaced, the
new seat must be approved for wheelchair transit,
installed and used as indicated in the manufacturer's
instructions.
5. the Wheelchair tiedown and occupant restraint
system (Wtors) should be compatible with the
specific wheelchair, used as indicated in the manu-
facturer's instructions and should comply with the
performance requirements of Iso standard 10542.
6. the wheelchair must be forward facing during
transport.
7. In order to reduce the potential of injury to vehicle
occupants wheelchair-mounted accessories such
as trays and respiratory equipment should be
removed and secured separately.
8. this product is intended for use by adults ranging
in weight from 79 lbs (35 kg) to 300 lbs (136 kg).
9. Postural support devices such as pelvic positioning
belts, anterior trunk supports or postural supports
such as lateral trunk supports should not be relied
on for occupant restraint in a moving vehicle unless
they are labeled as conforming to Iso standard
16840-4.
10. alterations or substitutions should not be made to
the structure, parts or components, without con-
sulting the manufacturer.
11. Backshell mounting bracket must be attached in the
"leg up" position for transit use. (see below)
top of back
correct bracket
orientation for transit
FaILurE to hEED thEsE WarnIngs
could cause seVere InJury To The
WhEELchaIr rIDEr or othErs.
13
TRa NSIT SaF ET Y
Incorrect bracket
orientation for transit
WarnIng
106109 Rev. D

Advertisement

Table of Contents
loading

Table of Contents