Options - Stabilising Bar; Options - Headrests; Options - Transit Wheels; Options - One-Hand Operation - Sunrise Medical Breezy RubiX2 Directions For Use Manual

Options - Stabilising Bar

RECLINER STABILISING BAR
Open star-knob (1) and swing the
stabilising bar (2) out of the way
before folding the chair.
To reinstate the wheelchair, reverse
the above procedure, (Fig.47).
DANGER!
• Before using the wheelchair
ensure that the stabiliser bar and
star-knobs are in place and are
tightened correctly.
• Never use the stabiliser bar to lift the chair!
SWINGAWAY STABILISING
BAR
This bar is used to stabilise the
backrest. To be able to fold the
wheelchair, the release lever (1)
must be pushed inwards and the
stabilising bar must be flipped
downwards. When unfolding the
wheelchair, please make sure that
the stabilising bar is locked into
position (Fig. 48).
FOLDING STABILISING BAR
This bar is used to stabilise the
backrest. To be able to fold the
wheelchair, the stabilising bar must
be pushed downwards in the middle
(1). To completely unfold the
wheelchair, the carrying handle (2)
must be pulled upwards, (Fig.49).
Fig.47
2
1
Fig.48
1
Fig.49
Options – Headrests
HEADRESTS
The headrest can be raised and moved
both forwards and backwards. To do this,
simply loosen the screw, adjust the
headrest to the desired position, and
tighten the screw (see the section on
torque) (Fig. 50).
COMFORT HEADREST
For adjusting the height open knob
and position the headrest in the
desired height. Finally tighten the
knob again, (Fig.51).
Options – Transit wheels
TRANSIT WHEELS
Transit wheels should be used wherever your wheelchair would be
too wide if the rear wheels were used (e.g., in
airplanes, buses, etc.). After the rear wheels have been
removed with the aid of the quick-release axles, the
transit wheels can immediately be used to continue
riding. The transit wheels are mounted so that they
are approx. 3 centimeters above the ground when not
in use. They are thus out of the way when riding,
transporting or when tipping to pass over obstacles
(e.g., kerbs, steps, etc.) (Fig. 52).
CAUTION:
Your wheelchair does not have any wheel locks when
the transit wheels are being used.
Options – One-hand operation
ONE-HAND OPERATION
To move the wheelchair in a straight
line, both hand wheels must be
operated. If the wheelchair is to be
folded up, remove the pull-off bar by
pushing it inwards (Fig. 53).
CAUTION:
To avoid injury, always make sure
that all connections are firmly in
place.
Fig.50
Fig.51
Fig.52
Fig.53
Rubix2 21