General Operation - Sanyo ECD-T1540 Operating Manual

GENERAL OPERATION

5 10
S-MOD
1 3 6
TURNING THE POWER ON........................Any button
Install the front panel and press any button (except
TURNING THE POWER OFF .................................. .. (1)
When system is on, press the POWER button (1) to turn off the unit.
VOLUME LEVEL CONTROL.......................................(2)
Rotate the VOLUME dial (2) to adjust the volume level.
ADJUSTING THE SOUND
CHARACTERISTICS ..................................... ......(2), (3)
Press the SEL button (3) shortly:
1. Each time you press the SEL button (3) shortly, the item changes as follows;
VOL
(Volume)
2. Rotate the VOLUME\CH-SEL dial (2) to adjust the selected item. Make the adjustment within
5 seconds after selecting. After 5 seconds, the display window will revert to display priority.
BASS (BAS 00)
TREBLE (TRB 00)
BALANCE (BAL L=R)
FADER (FAD F=R)
Beep Sound Adjustment:
Press and hold the SEL button (3) for several seconds to enter beep sound adjustment mode,
then rotate the VOLUME dial (2) clockwise or counter-clockwise to select as follows:
BEEP 2ND
- BEEP 2ND mode:
The beep is only generated when all allowed double function button is pressed for several
seconds.
2
VOLUME
LOUD/
P.SCAN
ENTER
7
BAS TRE
(Bass) (Treble)
Adjustment Range
BAS –10
TRB –10
10L
10F
BEEP ALL
45W x 4
SAT
and button) when ACC is on.
BAL FAD
(Balance) (Fader)
BAS 10
TRB 10
10R
10R
BEEP OFF
6
8 9
MANU/SKIP
4