Photron FASTCAM ultima SE User Manual page 52

P o w e r O n P o w e r O n
APPLYING POWER T APPL YING POWER TO THE PROCESSOR
Turn the front panel power switch on. The Processor configures itself, when power Turn the front panel power switch on. The Processor configures itself, when power
is applied, to the following conditions: is applied, to the following conditions:
1. 1.
Live - Off Live - Off
2. Rec Rate - 4500 2. Rec Rate - 4500
3. Rec Mode - START 3. Rec Mode - START
4. ID No - 01 4. ID No - 01
5. Report - On 5. Report - On
6. Playback rate - 30 fps 6. Playback rate - 30 fps
The picture on the video monitor will appear as follows: The picture on the video monitor will appear as follows:
NOTE NOTE
You should always perform an Aux Mem recording before using the FASTCAM ultima You should always perform an Aux Mem recording before using the FASTCAM ultima
SE. The electronics, starting with the sensor in the Imager, may cause fixed pattern SE. The electronics, starting with the sensor in the Imager, may cause fixed pattern
noise and shading errors in the pictures seen on the monitor. These unwanted artifacts noise and shading errors in the pictures seen on the monitor. These unwanted artifacts
can be corrected by making an Aux Mem recording following the procedure on the next can be corrected by making an Aux Mem recording following the procedure on the next
page. page.
O THE PROCESSOR
4-4 4-4