Photron FASTCAM ultima SE User Manual page 32

Recording Operation Recording Operation
STAR ST ART T
Press the Mode Sel button as many times as needed to illuminate the Start LED. Press the Mode Sel button as many times as needed to illuminate the Start LED.
Press the Ready button and then the Record button to start a recording. The proces- Press the Ready button and then the Record button to start a recording. The proces-
sor will record until every frame in memory has an image stored in it. The processor sor will record until every frame in memory has an image stored in it. The processor
stops recording when the memory is full. stops recording when the memory is full.
A trigger signal input through either the Trigger In or the Trigger SW In connector on A trigger signal input through either the Trigger In or the Trigger SW In connector on
the rear panel of the processor has the same effect as pressing the Record button. To the rear panel of the processor has the same effect as pressing the Record button. To
make a Start mode recording using an external trigger signal, select the Start mode as make a Start mode recording using an external trigger signal, select the Start mode as
above, press the Ready button and then supply a trigger signal input either to Trigger In above, press the Ready button and then supply a trigger signal input either to Trigger In
or to Trigger SW In. Remember Trigger In requires a positive 10 ma TTL level signal or to Trigger SW In. Remember Trigger In requires a positive 10 ma TTL level signal
to drive the opto-isolator or Trigger SW In requires a simple contact closure, with no to drive the opto-isolator or Trigger SW In requires a simple contact closure, with no
voltage present, across its connector. voltage present, across its connector.
STAR ST ART MODE FRAME NUMBERING T MODE FRAME NUMBERING
Memory / Frames
512 megabytes / 8192
1 gigabyte / 16384
1.5 gigabytes / 24576
First Frame Trigger Point Last Frame
1 1
1 1
1 1
3-6 3-6
8,192
16,384
24,576