Table of Contents
Advertisement
Operation
Basic operation
Press VIDEO IN to select the input format and frame rate.
VIDEO IN
Press FORMAT(F1) to select an HxV value. Pressing the function key or turning the
FORMAT
knob will cycle through the range of choices. AUTO SD or AUTO HD will attempt to
detect the input format if a signal is present.
Press F RATE(F2) to select the frame rate. Pressing the function key or turning the knob
F RATE
will cycle through the range of choices. AUTO SD or AUTO HD will attempt to detect the
input format if a signal is present.
Press VIDEO OUT to select the output format and frame rate.
VIDEO OUT
Press FORMAT(F1) to select an HxV value. Pressing the function key or turning the
FORMAT
knob will cycle through the range of choices.
Press F RATE(F2) to select the frame rate. Pressing the function key or turning the knob
F RATE
will cycle through the range of choices.
This will set the system to nominal conversion settings. These settings can be modified under the
following menus.
Press FILTER to change the conversion filters and to add enhancement.
FILTER
Press H RESP(F1) to select a horizontal filter response. Pressing the function key or
H RESP
turning the knob will cycle through the NARROW, STANDARD and WIDE choices.
Press V RESP(F2) to select a vertical filter response. Pressing the function key or
V RESP
turning the knob will cycle through the NARROW, STANDARD and WIDE choices.
Press H ENH(F3) to add horizontal enhancement. Pressing the function key or turning
H ENH
the knob will change the amount in 0.5dB steps.
Press V ENH(F4) to add vertical enhancement. Pressing the function key or turning the
V ENH
knob will change the amount in 0.5dB steps.
Press 2-D ENH(F5) to add both horizontal and vertical enhancement at the edge of the
2-D ENH
band. Pressing the function key or turning the knob will change the amount in 1dB steps.
This control may have limited effect on upconverted signals.
Press RESIZE to change the zoom, pan or crop settings. Press EXIT or turn the knob
RESIZE
until ZOOM/PAN is displayed. The double arrow ">>" signifies that multiple menus are
available at this level.
Press ZM MODE(F1) and select VARIABLE.
ZM MODE
10
Advertisement
Table of Contents
