Gatekeeper Systems Fleet Safety, Security and Tracking Solutions G4-304SD1 User Manual & Installation Manual page 8

G4-304SD1 User Manual & Install Guide
Preparing to Install
Customers shall be responsible for addressing any systems on the bus that require

attention as a result of disconnecting the bus battery. This includes, but is not limited
to, entering a radio theft code, programming radio stations etc.
Installing the product
All Gatekeeper Systems employees or contractors who perform electrical work (eg.

installing, servicing or removing a G4-304SD1, installing a backup camera system, etc)
on a customer vehicle shall ensure that the battery in the vehicle is disconnected before
work commences.
Operating the product
The G4-304SD1 has an operating temperature range of -40°C to +65°C. It is good

practice to ensure that the product is mounted in a suitable location which does not
exceed acceptable temperature ranges during the course of normal operations.
Do not remove the cover of the product as this will void the warranty.

When a system has shipped with a GPS antenna, please ensure that the GPS antenna is

mounted externally on the roof of the bus with a clear view of the sky, and with the
magnetic side facing down.
The SD Card is specially formatted for use in your G4-304SD1. Please do not format it

yourself using Microsoft Windows. A SD card from a G4-304SD is not compatible with
the G4-304SD1 and so would require to be formatted in the G4-304SD1 prior to use.
Prior to removing the SD card for viewing video on a pc, it is essential that the G4-
304SD1 be fully powered down before removal of the SD card. Failure to do this will
result in data corruption and thereby loss of video.
Updating the product
Firmware updates (available from www.gatekeeper-systems.com) are system and

product model specific. These firmware updates must be applied to the G4-304SD1
system only.
Repairing the product
Your G4-304SD1 doesn't have any user-serviceable parts. Do not open or disassemble

it, or attempt to repair it or replace any components.
Disassembling the G4-304SD1 may damage it or may cause injury to you. If your

product needs service, is damaged, or malfunctions, contact Gatekeeper Systems for
assistance. If you attempt to open it, you risk damaging your product, and such damage
isn't covered by the warranty on your G4-304SD1.
If at any time there is a question about how to proceed, please contact Gatekeeper Systems immediately
at either 1-888-666-4833 or 1-604-864-6187 for assistance. Review all available installation
documentation, including technical bulletins. Additional resources, technical bulletins and product
tutorials can be found in the Support section of www.gatekeeper-systems.com.
The battery must be disconnected from the vehicle before
working on the electrical system of the vehicle when installing,
servicing or removing Gatekeeper products.
8 of 149