Installing The Led Luminaire Module - Modern Forms AXIS Installation Instructions Manual

12. INSTALLING THE LED LUMINAIRE MODULE

WARNING: Before starting installation, disconnect the power by turning off
the circuit breaker or removing the fuse at fuse box.
NOTE: If you do not plan to install the luminaire module with your fan at
this time, skip to step 5.
1. Remove 1 of the 3 screws from the adapter plate and keep it for future
use. Loosen the other 2 screws (Do not remove).
2. Raise and hold the LED luminaire module close to the adapter plate and
proceed to secure the wire connections. Connect the white wire connectors
from the luminaire module to the white wire of the fan. Follow the same
procedure with the black wire connectors. (Fig. 19)
3. Tuck connections neatly into adapter plate. Place the luminaire module
key holes over the 2 screws previously loosened from the adapter plate.
Turn luminaire module until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened and the one
previously removed. (Fig. 19)
4. Raise acrylic shade up against the luminaire module, and secure it to fan
by turning acrylic shade clockwise until snug. Do not overtighten.
F R- W1 8 0 3
Connection plugs
LED Luminaire module
FIGURE 19
Adapter plate
Screws
Glass
shade
17