Advertisement
3.1
3.1
Operation
The Blade Cartridges
Both the bevel and 5 undercut blade holders are fitted with Blade Cartridges, to release the cartridge
from either of the blade holders slacken the blade clamping screw (B) and pull the cartridge out, gripping
the black plastic pin (A).
The blade is held onto the cartridge by a strong magnet, place the blade between the two raised edges
and slide it so the back edge of the blade touches the depth adjustment screw. To adjust the blade
depth turn the adjustment screw (C) clockwise to extend the blade length and counter-clockwise to
reduce it. Always check that the blade is properly located in the cartridge before loading it into the blade
holder.
Each cartridge has a different coloured label to help with identification and calibration if pre-set to suit
different thicknesses of board. Additional blade cartridges are available from your Keencut distributor.
Experimentation with blade types is advised to product optimum results with the various thicknesses and
types of flexo plate used.
Advertisement
