Garmin G1000 Reference Manual page 118

appendix
3) Turn the G1000 system ON. A prompt similar to the following illustration is
displayed:
4) Press the YES Softkey to update the navigation database in the MFD.
5) After the update completes, the display starts in normal mode.
6) Turn the G1000 system OFF and remove the SD card from the top card slot.
7) Repeat steps 2 through 6 for PFD1.
8) Repeat steps 2 through 6 for PFD2.
9) Apply power to the system and press the ENT Key to acknowledge the
startup screen.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) Press the Display Database Selection Softkey to show navigation database
information for each display (MFD1 DB, PFD1 DB, PFD2 DB).
102
Garmin G1000 Cockpit Reference Guide for the Cessna Caravan
Navigation Database Load Prompt
Check Database Cycle Number (MFD shown)
190-00748-02 Rev. B