Garmin G1000 Reference Manual page 61

displaying traffic on the traffic map page
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Press the NORMAL Softkey to begin displaying traffic. 'OPERATING' is
displayed in the Traffic Mode field.
4) Press the ALT MODE Softkey to change the altitude volume. Select the
desired altitude volume by pressing the BELOW, NORMAL, ABOVE, or
UNREST (unrestricted) Softkey. The selection is displayed in the Altitude
Mode field.
5) Press the STANDBY Softkey to place the system in the Standby Mode.
'STANDBY' is displayed in the Traffic Mode field.
6) Rotate the Joystick clockwise to display a larger area or rotate counter-
clockwise to display a smaller area.
system self test
1) With the Traffic Map Page displayed, set the range to 2/6 nm.
2) Press the STANDBY Softkey.
3) Press the TEST Softkey.
4) Self test takes approximately eight seconds to complete. When completed
successfully, traffic symbols are displayed and a voice alert "TAS System Test
OK" is heard. If the self test fails, the system reverts to Standby Mode and
a voice alert "TAS System Test Fail" is heard.
displaying traffic on the navigation map
1) Ensure TAS is operating.
2) With the Navigation Map displayed, press the MAP Softkey.
3) Press the TRAFFIC Softkey. Traffic is now displayed on the map.
190-00748-02 Rev. B Garmin G1000 Cockpit Reference Guide for the Cessna Caravan
hazard avoidance
45