Table of Contents
Advertisement
Doc Title
:
Product Data – User's Guide
Model
:
MBP28
1. Take off the belt clip/stand.
2. Slide off the battery compartment cover.
3. Insert the plug of the battery pack into the jack inside the battery compartment, and fit the battery pack into the
compartment.
4. Replace the battery compartment cover, and reinstall the belt clip/stand (refer to section 2.3).
5. Insert the DC plug of the power adapter with the bigger DC plug into the DC jack in the side of the parent unit.
6. Connect the other end of the power adapter a suitable power outlet.
7. The Charging Indicator comes on.
NOTE
Only use the provided power adapter and battery pack.
The parent unit can work with the power adapter connected but without a battery pack installed.
2.3
Belt clip/stand on parent unit
1. Attach the belt clip to the lock slots on the back sides.
2. On normal state, the belt clip could be hanged on the belt directly.
3. Lift up the belt clip and rotate 180°, then the parent unit could stand on the desk. Do NOT hang on the human
body.
3
USING YOUR BABY MONITOR
Please read these instructions carefully, and be aware that this baby monitor is only intended as an aid. It is not a
substitute for responsible, correct parental supervision.
3.1
Power on/off the parent unit
1. When the parent unit is off, press <POWER/BACK> until you hear a beep and the Power Indicator starts to
flash. The parent unit will search for and link itself to the registered camera units.
2. When the parent unit is on, press and hold <POWER/BACK> until the Power Indicator is off. The parent unit is
now powered off, although the display may take a few seconds to go off fully.
3.2
Power on/off the camera unit
1. When the camera unit is off, press <POWER> to power it on. The Power/Link Indicator will flash for a few
seconds until it links with the parent unit and stays steadily on.
2. When the camera unit is on, press and hold <POWER> until the Power/Link Indicator is off. The camera unit is
now powered off.
NOTE
If you place the parent and camera units too close together, you may hear a high pitched noise. This is not a fault.
The units are designed to be operated at some distance apart, e.g. in separate rooms, so move the units further
apart.
3.3
Adjust speaker volume of parent unit and camera unit
There are 5 volume levels on the camera unit, and 6 levels on the parent unit, including VOLUME OFF. The
volume level of parent unit will be shown on the status bar when you adjust the volume.
1. Press < > or < > on the parent unit or < > or < > on the camera unit to adjust the respective volume level.
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Belt clip position
Revision :
Page(s) :
Desktop position
R.00
9 of 17
Advertisement
Table of Contents
