Table of Contents
Advertisement
Doc Title
:
Product Data – User's Guide
Model
:
MBP28
5. Press <MENU> to confirm.
NOTE
When LCD is off, any alert message will turn on the LCD.
4.6
Select camera unit
The system supports up to four camera units. You can select any registered camera unit and view the picture from
that camera.
1. Press <MENU> to access main menu.
2. Press < > or < > to select BU Selection.
3. Press <MENU> and < > or < > to select the desired camera unit or All Baby Units.
4. Press <MENU> to confirm. The parent unit will start to connect with the selected camera unit, while the other
unit(s) will be in shutdown mode. The CAM x icon (e.g. <Camera 2 icon>) will be shown on the status bar, when
displayed, where x is the baby unit number of the selected camera unit.
When All Baby Units is selected, the screen of the parent unit will automatically switch among all the registered
camera units, with each camera unit being selected in turn at about 30 second intervals.
NOTE
Only registered camera unit(s) will be shown in the selection list.
4.7
Register a camera unit
IMPORTANT
When you purchase your baby monitor system, all cameras are already registered to the parent unit, so you do not
need to register them.
Camera registration is only necessary if one has become faulty or if you buy a new one.
You can register up to 4 cameras to the parent unit.
To register a camera unit:
1. Press <MENU> to access main menu.
2. Press < > or < > to select REGISTER.
3. Press <MENU> to confirm. The parent unit will display Registration mode, and then display Registering...
which indicates it has entered the registration mode.
4. Press and hold <VOLUME +> on the camera until it emits a beep tone.
5. There will be a beep and the display will show Registered when the registration is successfully completed, and
the camera will be assigned a baby unit number, which can be checked from the parent unit.
4.8
Reset
You can restore all the adjustable settings of the registered camera units and parent unit to the original factory
settings.
1. Press <MENU> to access main menu.
2. Press < > or < > to select RESET.
3. Press <MENU> to confirm. The display will show Confirm?.
4. Press <MENU> to confirm again. The parent unit and the registered camera units will be reset.
5
DISPOSAL OF THE DEVICE (ENVIRONMENT)
At the end of the product lifecycle, you should not dispose of this product with normal household
waste. Take this product to a collection point for the recycling of electrical and electronic equipment.
The symbol on the product, user's guide and/or box indicates this.
Some of the product materials can be re-used if you take them to a recycling point. By reusing some
parts or raw materials from used products you make an important contribution to the protection of the environment.
Please contact your local authorities in case you need more information on the collection points in your area.
Dispose of the battery pack in an environmentally-friendly manner according to your local regulations.
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Revision :
Page(s) :
R.00
12 of 17
Advertisement
Table of Contents
