Jeep Renegade 2018 User Manual page 108

Enhanced Accident Response System Reset
Procedure
After the event occurs, when the system is
active, a message regarding fuel cutoff is
displayed. Turn the ignition switch from igni-
tion AVV/START or MAR/ACC/ON/RUN to ig-
nition STOP/OFF/LOCK. Carefully check the
vehicle for fuel leaks in the engine compart-
ment and on the ground near the engine
compartment and fuel tank before resetting
the system and starting the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the
instrument panel, may both be blinking and
will continue to blink. In order to move your
vehicle to the side of the road, you must
follow the system reset procedure.
106
Customer Action Customer Will See
NOTE:
Each step MUST BE held for at least two
seconds
1. Turn ignition
STOP/OFF/LOCK.
(Turn Signal Switch
Must be placed in
Neutral State).
Right turn light
2. Turn ignition MAR/
BLINKS.
ACC/ON/RUN.
Left turn light is OFF.
Right turn light is ON
3. Turn right turn SOLID.
signal switch ON. Left turn light
BLINKS.
Right turn light is
4. Place turn signal OFF.
in neutral state. Left turn light
BLINKS.
Right turn light
5. Turn left turn sig- BLINKS.
nal switch ON. Left turn light is ON
SOLID.
Right turn light
6. Place turn signal
BLINKS.
in neutral state.
Left turn light is OFF.
Customer Action Customer Will See
NOTE:
Each step MUST BE held for at least two
seconds
Right turn light is ON
7. Turn right turn SOLID.
signal switch ON. Left turn light
BLINKS.
Right turn light is
8. Place turn signal OFF.
in neutral state. Left turn light
BLINKS.
Right turn light is ON
9. Turn left turn sig- SOLID.
nal switch ON. Left turn light is ON
SOLID.
10. Turn left turn
signal switch OFF. Right turn light is
(Turn Signal Switch OFF.
Must be placed in Left turn light is OFF.
Neutral State).
11. Turn ignition
STOP/OFF/LOCK.