Enabling And Disabling Rear Parksense; Service The Rear Parksense System; Parksense System Usage Precautions - Jeep Renegade 2018 User Manual

In general, the vehicle is closest to the ob-
stacle when the display shows only a flashing
arc and the chime becomes continuous.
The color on the display depends on the
distance and location of the obstacle.

Enabling And Disabling Rear ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch.
When the Rear ParkSense switch
is pushed to disable the system,
the instrument cluster display will
show a message
"PARKSENSE DISABLED" for approximately
five seconds. Refer to "Instrument Cluster
Display" in "Getting To Know Your Instru-
ment Panel" in your Owner's Manual for fur-
ther information.
The Rear ParkSense switch LED will be on
when Rear ParkSense is disabled or requires
service. The Rear ParkSense switch LED will
be off when the system is enabled. If the Rear
ParkSense switch is pushed, and requires
service, the Rear ParkSense switch LED will
blink momentarily, and then the LED will be
on.
Rear ParkSense will remember the previous
state when the vehicle is switch off.
CAUTION!
After turning OFF the ignition, the Rear
ParkSense remains in this setting until the
next ignition cycle, even in the case of
changing the setting of starting RUN to
OFF and then again in RUN.

Service The Rear ParkSense System

During vehicle start up, when the Rear
such as
ParkSense System has detected a faulted
condition, the instrument cluster display will
actuate a single chime, once per ignition
cycle, and it will show a message such as
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or the "PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED". Refer to "In-
strument Cluster Display" in your Owner's
Manual for further information. When the
gear selector is moved to REVERSE and the
system has detected a faulted condition, the
instrument cluster display will show a mes-
sage such as "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" mes-
sage for for approximately five seconds. Un-
der this condition, Rear ParkSense will not
operate.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display, make sure the outer surface and the
underside of the rear fascia/bumper is clean
and clear of snow, ice, mud, dirt or other
obstructions and then cycle the ignition. if
the message continues to appear, see an
authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" appears in the instrument clus-
ter display, see an authorized dealer.

ParkSense System Usage Precautions

NOTE:
• Ensure that the outer surface and the un-
derside of the rear bumper is clean and
clear of snow, ice, mud, dirt or other ob-
struction to keep the Rear ParkSense sys-
tem operating properly.
• Jackhammers, large trucks, and other vi-
brations could affect the performance of
Rear ParkSense.
141