Vest Configuration - Aqua Lung EBIS-3000 User Manual

18

Vest Configuration

1. Disconnect the upper and lower inflator tubes from the "T" connector on the
vest (Fig. 16). Remove the upper inflator tube from the hose retainer (Fig. 17).
Lower Tube
Figure 16
2. Check the handwheel is closed and
the system depressurized. Disconnect
the inflator hose from the QD fitting
(Fig. 18) if this was not done during
the Preparation and Set-up section
of the manual.
3. Insert the inflator hose through the
bottom and out the top of the hose
retainer. Insert the upper inflator tube
through the top and out the bottom of
the hose retainer (Fig. 19).
Upper Tube
EBIS - 3000 & 4500 User's Manual
Hose Retainer
Figure 17
Position
Figure 18
Figure 19
"OFF"