Figure 73. Installing the network daughter card
Next steps
1
Install the
expansion card riser 2
2
Follow the procedures in
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal drives of your system. The controller supports SAS and SATA drives and also enables you
to set up the drives in RAID configurations as supported by the version of the storage controller.
This section contains information about the removal and installation of the integrated storage controller card.
Removing the integrated storage controller card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedures in
3
Remove the
air
shroud.
4
Remove the
expansion card riser
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
2
Lift the integrated storage controller cable away from the integrated storage controller.
110
Installing and removing system components
or the
rear drive
cage, depending on the configuration of your system.
After working inside your system
Safety instructions
Before working inside your system
1.