Table of Contents
Advertisement
Figure 41. Removing a drive from the drive carrier
Next step
If applicable, install the a
drive into the drive
Installing a drive into the drive carrier
Prerequisites
Follow the safety guidelines listed in
CAUTION:
Mixing drive carriers from other generations of NAS systems is not supported.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.
Steps
1
Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
2
Align the screw holes on the drive with the screws holes on the drive carrier.
When aligned correctly, the back of the drive is flush with the back of the drive carrier.
3
Using the Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
78
Installing and removing system components
carrier.
Safety
instructions.
Advertisement
Table of Contents
