Smartrunk Jltm And Conventional Modes; Smartrunk Iitm Operation - Icom IC-F1020 Instruction Manual

OPTIONAL SmarTrunk
IITM
OPERATION
13
• SmarTrunk
IITM
and
conventional modes
This transceiver meets to SmarTrunk II™ functions.
The optional UT-105 allows communication in conventional
channels or SmarTrunk IITM channels. Select a channel bank
for SmarTrunk
II™
before trunking operation.
• Push
[BK
up] or
[BK ON]
one or more times to select a chan-
nel bank for conventional channels or SmarTrunk IF M chan-
nels.
• Pushing
[CH
up] or
[CH
ON] while pushing [BK s] can also select
the channel bank.
• Scanning starts when a channel bank for SmarTrunk II™ is se-
lected,
• Contact your dealer for channel bank details.
~ NOTE: Connect an optional DTMF microphone. Contact
~
your dealer for details.
• SmarTrunk
IITM
operation
These features are enabled by a dealer or system operator
and may not be available in your system. Contact your dealer
for details.
~
Placing a telephone call
Enter the phone number followed by [1], [*].
• A high-pitched beep indicates that the number is accepted.
• When the called party answers, push the [PTT] switch to talk, and
release it to listen.
o
Calling another local system subscriber
Enter the subscriber number followed by [3],
[*].
• A high-pitched beep indicates that the number is accepted.
• You hear ringing, then two short beeps when the subscriber an-
swers.
• If the other subscriber is on another call or out of range, you hear a
fast busy signal and the call terminates automatically.
c- Receiving a call
When you hear ringing, push [*] to answer.
• For a group call, you hear a short ring followed by two short beeps.
You do not have to answer a group call to hear it over the air.