Table of Contents
Advertisement
STARTING PROCEDURE
STARTING A COLD ENGINE
1. Lay the product on the ground. Ensure
that the cutting means will not contact
anything when it starts to rotate. Press
the primer bulb 10 times.
NOTE: After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
Set the choke lever to
2. Hold down the throttle lock and then
squeeze the throttle trigger completely
and pull the starter grip until the engine
attempts to start. Do not pull the starter
grip more than 4 times. Keep the throttle
trigger squeezed completely through
step 4.
3. Set the choke lever to
Pull the starter grip until the engine
starts. Do not pull the starter grip more
than 6 times.
NOTE: If the engine does not start,
repeat the procedure from setting the
choke lever to
choke position.
4. Allow the engine to run for 10 seconds,
then set the choke lever to
1
2
choke position.
3
2
choke position.
3
position.
4
1
x10
1
1
2
1
2
4x
3
4 4
6x
4
6 6
2
11
Advertisement
Table of Contents
