Table of Contents
Advertisement
STARTING PROCEDURE
STARTING A COLD ENGINE BY ELEC-
TRICAL STARTER
1. Install the starter bit into the electrical
starter with the pentagon bit facing
outside. Push the F/R button to the left
until the pentagon symbol shows on the
F/R button.
2. Insert the battery pack into the electrical
starter until it clicks into place.
WARNING: Keep your hands away from
the starter bit to avoid injury.
3. Lay the product on the ground. Ensure
that the cutting means does not come in
contact with anything. Press the primer
bulb 10 times.
NOTE: After the 7th press, the fuel
should be visible in the primer bulb. If
not, continue pressing until the fuel is
visible.
Set the choke lever to
1
2
choke position.
3
2
1
x10
1
1
2
13
Advertisement
Table of Contents
