Table of Contents
Advertisement
STARTING PROCEDURE
4. Hold down the throttle lock and then
squeeze the throttle trigger completely
with your left hand and keep the throttle
trigger squeezed completely through
steps 6.
Hold the product with one hand and use
your other hand to insert the starter drive
shaft into the engine starter housing.
Make sure the starter bit is properly
engaged.
Press and hold the electrical starter
switch button until the engine attempts to
start. Do not press the electrical starter
for more than 4 seconds.
5. Set the choke lever to
position.
Hold down the throttle lock and then
squeeze the throttle trigger.
Press and hold the electrical starter
switch button until the engine starts. Do
not press the electrical starter for more
than 4 seconds.
NOTE: If the engine does not start,
repeat the procedure from setting the
choke lever to
choke position. Do not
repeat the procedure more than 1 time.
If the engine still fails to start, see the
solution instruction for the "Flooded
engine" in the "Troubleshooting" section
of this manual.
6. Allow the engine to run for 10 seconds,
and then set the lever to
7. Hold down the throttle lock and then
squeeze the throttle trigger to start using
the product.
14
4
5
choke
1
6
position.
7
1
2
2
3
2
1
2
4
4s
4s
3
4
4s
4s
1
Advertisement
Table of Contents
