STARTING PROCEDURE
STARTING A WARM ENGINE
1. Lay the product on the ground. Ensure
the cutting means will not contact
anything when it starts to rotate. Press
the primer bulb 10 times. Set the choke
lever to
position.
2. Hold down the throttle lock and then
squeeze the throttle trigger completely
and pull the starter grip until the engine
starts. Do not pull the starter grip more
than 6 times.
NOTE: If the engine does not start
by following this procedure, follow
the Starting a Cold Engine procedure
section in this manual.
If the engine still fails to start, see the
solution instruction for the "Flooded
engine" in the "Troubleshooting" section
of this manual.
12
1
x10
1
2
1
2
2
6x
3
6 6