Initial Operation Of The Device; Inserting/Replacing Batteries; Activating And Setting The Date/Time - visomat comfort 20 Instructions For Use Manual

C
• Every automatic blood pressure monitor can produce unusu-
al measurement results every now and then. Check for your-
self: did you adhere to the above-mentioned instructions for
use? If necessary, repeat the measurement after a short rest
of approximately three to five minutes to recover the blood
circulation in the arm.

4. Initial operation of the device

4. Initial operation of the device
Insert the batteries provided into the device.
If the device is to be operated using mains power, the cable con-
nector of the mains adapter (not supplied) must be plugged into
the socket on the right-hand side of the device. The batteries are
automatically switched off.
Please only use the visomat mains adapter. See "Original spare
®
parts and accessories" on page 60.

5. Inserting/replacing batteries

• Remove the battery compartment cover on the underside of
the device.
• Remove the old batteries from the device and insert the new
ones. Please ensure correct polarity (marking in battery com-
partment).
• Close the battery compartment by clipping the battery cover
back into the device.
When the "empty battery " symbol first appears in the display,
you are still able to take around 30 measurements. Please re-
place the batteries within this time frame.
EN-44
Operating the device Operating the device

6. Activating and setting the date/time

The device has a date/time function that can be activated as re-
quired. This function is deactivated on delivery.
When the date/time function is activated, the measurement re-
sults are saved along with their date and time. This can make it
easier to view the readings at a later point.
Activating and deactivating the date/time function
Press the Start/Stop button to activate the date/time function.
Then immediately press one of the two Memory buttons while
the full display is still visible. The function can be deactivated at
any time using the same procedure.
When the date/time function is activated, the
device continues to display the time even when
it is switched off. The power consumption for
this is extremely low.
Setting the date/time
Initially, the display will show the four-digit year
number (Figure 1). Press Memory button 1 to re-
duce the year number or Memory button 2 to
increase the year number. Confirm the entry by
pressing the Start/Stop button.
You are now able to set the month. (Figure 2).
Press Memory button 1 to reduce the value or
Memory button 2 to increase the value. Set the
correct month and confirm the entry by pressing
the Start/Stop button.
Repeat these steps to enter the day (Figure 2)
and the hours and the minutes (Figure 3).
C
Figure 1
Figure 2
Figure 3
EN-45