Initial Operation Of The Unit; Inserting/Replacing Batteries; Activating And Setting The Date/Time - visomat comfort eco Instructions For Use Manual

C

4. Initial operation of the unit

Insert the supplied batteries into the unit.
If the unit is to be operated from the mains power supply, the
cable plug of the mains adapter (not included in the scope of
delivery) must be inserted into the connection socket of the unit.
The batteries are switched off automatically.
Please use only the visomat type A2 mains adapter. See original
®
spare parts and accessories, Page 59.

5. Inserting/replacing batteries

• Opening the battery compartment
Open the cover of the battery compartment on the under-
side of the unit.
• Inserting batteries
Remove the old batteries from the unit and insert the new
ones. Please observe proper polarity (marking in battery
compartment).
• Closing the battery compartment
Close the battery compartment by clipping the battery cover
back into the unit.
When the display shows the "Flat battery
symbol for the first time, the unit will still have
enough charge for about 30 measurements.
Please change the batteries during this period.
EN-44
Operating the unit
"
Operating the unit

6. Activating and setting the date/time

The unit has a date/time function which you can activate where
necessary. This function is deactivated when the unit is deliv-
ered.
Activating the date/time function
To activate the date/time function, press the Start/Stop button
and then immediately, while the full display is visible, the Mem-
ory button. This function can be deactivated at any time in the
same way.
Setting the date/time
The four-digit number representing the year
appears in the display first (Fig. 1). Press the
Memory button to set the year. Press the Start/
Stop button to confirm the selected year and
proceed to setting the date.
Set the month with the Memory button and
confirm this with the Start/Stop button. Set the
day, hours and minutes in the same way (Fig.
2, Fig. 3).
Changing the date/time
To change the date/time function, take out a
battery and wait until the display goes blank.
Now you can reactivate the date/time function
and reset the date and time again.
Deactivating the date/time function
To deactivate the date/time function, press the
Start/Stop button and then immediately the
Memory button.
C
Fig. 1
Fig. 2
Fig. 3
EN-45