Preparing The Oven - ROSIERES FE9163 Instructions For Use, Maintenance And Installation Manual

- children or incapable people may only use the appliance under supervision
- adapters, multiple sockets and extension cables should not be used.
- in case of faults and/or malfunctions, switch off the appliance; do not attempt to repair it yourself.
If the cable is damaged, replace it immediately as follows:
- open the terminal board cover, remove the power cable and replace it with one of a relative length
with rubber insulation (H05RR-F) and sufficiently large for the rated power of the appliance.
This operation must be carried out by a qualified technician.
The earth wire (yellow - green) must be about 10 mm longer than the line wires.
In case the appliance needs repairing, contact an authorised technical service centre and make sure
original spare parts are used.
Non-compliance with the above points may jeopardise the safety of the appliance.
Preparing the oven for use
Clean the inside of the oven using non-abrasive soap and warm water, then rinse and dry.
Switch the oven on at maximum temperature for approximately 20 minutes in order to eliminate
oil, grease and remains of any other products used during manufacturing that can cause unpleasant
smells during cooking. The appliance must be electrically disconnected before cleaning.
Caution!
Keep children well away from the oven during operation.
4