Table of Contents
Advertisement
Editing the Sensor
Configuration
14
When a sensor arrives from the factory, it will not be properly configured for
the network. Sensors that are assigned (that is, in the "All sensors" list) can be
configured using SMT. Sensors are configured using the Configuration menu.
The configuration menu can be displayed by clicking on the Tools menu, or by
right-clicking on the appropriate sensor's icon.
To configure a sensor in the "All sensors" list by right-clicking, use the
following steps.
1.
Right click the name of the sensor to configure.
2.
From the right-click menu, click on "Configure." See the Sensor
Configuration dialog box.
To configure a sensor in the "All sensors" list using the Tools menu, use the
following steps.
1.
Click to highlight the name of the sensor to configure.
2.
In the menu bar, click Tools > Sensor > Configure. See the Edit
Sensor dialog box.
The Edit Sensor dialog box contains several views. Each view is used to
change some aspect of the selected sensors configuration. To change to any
of the views, click on the name of the view. Clicking on a view name displays
that view. Clicking on the view name a second time hides that view.
Sensor Hardware and Identification
This view of the configuration dialog box is used to change the sensor's name
and several other values. This view is also used to update a sensor's firmware
and reboot the sensor. It is also possible to remove the sensor from the SMS
assignment list.
Note: When entering data in the Sensor Hardware and Identification dialog
box, remember to click the "Finished" button before exiting the view.
RF Sensor User Guide
Advertisement
Table of Contents
