Table of Contents
Advertisement
8
The Setup Network Configuration window is used to view and manually set the
sensor's network configuration. The window shows two sets of configuration
data. The values displayed in shaded boxes on the right-hand side of the
window are the values currently being used by the selected sensor. To change
these values, enter the desired values in the text entry boxes on the left, and
click the Apply Changes button.
To change these stored network values, enter the desired values in the text
entry boxes on the left, then click the Apply Changes button. The new values
are applied to the RF sensor and now appear in the shaded boxes.
To leave this dialog box without changing a sensor's configuration, click the
box's close button.
If Microsoft Windows changes focus (if another program
window is placed on top of the SMT window) before clicking
either the Apply Changes button or the Exit button, it is
possible to lose track of the dialog box and SMT can appear
to be hung. This is normal Windows behavior. If this
happens, minimize all open windows and maximize the SMT
window to restore the dialog box.
Rebooting a Sensor
To reboot an RF sensor, use the following steps:
1.
From the Configuration window, click the Discover Sensors tab.
2.
When the SMT displays the RF Sensors that are present on the
SMS's local subnet, click to highlight the entry of the RF sensor to
reboot.
3.
Click the Reboot button at the bottom of the window.
Adding a Sensor to the SMS Sensor List
Add a sensor, from the list of available sensors, to the instance of SMS being
used through the SMT.
Note: SMT does not show if the sensor is currently used by a different instance
of SMS. Having all installation of SMT connects to the same instance of SMS
can prevent conflicts where multiple instance of SMT vie for the same sensors.
To add a sensor to SMS, use the following steps.
1.
From the list of available sensors in the Configuration window, select
the sensor to use and click on it to highlight its entry.
2.
At the bottom of the Configuration window, click on the button
marked, "Add to SMS."
Click the "Add to SMS," which causes the selected sensor to be displayed in
the "All sensors" list on the left of the Configuration window. To expand the All
sensors list, click the "+" button to the left of the "All sensors" heading.
RF Sensor User Guide
Advertisement
Table of Contents
