Genie Super-Straddle Operator's Manual page 24

Operator's Manual
Operating Instructions
sloped.
11 Adjust the outrigger screw jacks so that the
pads are in firm contact with the ground and the
Super-Straddle casters are slightly off the
ground. Use the bubble level on the Genie AWP
to level the straddle
platform. The bubble
level is on the base
of the AWP, below
the interlock display.
12 Open the C-hook on
the ladder.
13 Position the ladder
under the AWP
platform entry. Place
the C-hook over the rail
and drop the ladder down.
14 Pull out the snap pins
on each side of the
ladder to lower the
bottom step.
22
15 Operate the Genie AWP.
Lowering the Straddle Platform
1 Fully lower the Genie AWP.
2 Slightly raise the outriggers.
3 Carefully push the Super-Straddle away from the
straddle object. Return the machine to a firm
level surface.
4 Remove the frame retaining pins from each
corner of the Super-Straddle. The holes must be
aligned to remove the pins. Use the winch to
Rail
align the holes if needed.
5 Turn the winch handle to lower the straddle
platform. It may be necessary to lower one end
frame part way and then lower the other end.
6 Continue turning the winch handles until both
end frames are
lowered.
Ladder
Storage
Drop ladder down
Store the ladder on
the base frame cross
membrane.
To protect the safety
and operating instruction decals from scuffs and
scratches, do not store ladder over either end
frame.
After Each Use
Select a safe storage location - firm level surface,
weather protected, clear of obstruction and traffic.
Coil cord can be hooked to the end frame for
storage.
Super-Straddle
Second Edition • First Printing
Part No. 133409