Genie Super-Straddle Operator's Manual page 16

Operator's Manual
Inspections
10 Adjust the Super-Straddle to the desired length.
11 Insert the straddle
socket retaining
pins (attached to the
straddle sockets at
the front of the
Genie AWP)
through the straddle
length adjustment
holes.
12 Unhook the cords
from the storage
positions, and
connect the plugs in
each of the straddle
sockets.
14
Function Tests
13 Install a Genie AWP
outrigger at each
corner of the
Super-Straddle.
Adjust the outriggers
to level the machine
and raise the casters
slightly off the ground.
Note: The outriggers must be the correct size for
the Genie AWP.
14 Crank the winch and raise the straddle platform
about 2.5 cm, enough to allow the frame
retaining pins at each corner of the
Super-Straddle to be inserted into the first set of
holes. Do not raise the straddle platform past
the first set of holes.
15 To insert a frame retaining pin, align the holes
and lift up on the gray tab on the pin retaining
interlock box. The pin is fully inserted when the
gray tab stays up.
16 Insert frame retaining pins at each corner of the
Super-Straddle.
Note: Be sure to use the same hole position for
both pins on one end frame.
17 At the interlock display of the Genie AWP, insert
the key and turn to platform control.
18 Pull out the red Emergency Stop button to the
on position.
Result: The power light and all four outrigger
interlock display lights should come on.
Super-Straddle
Second Edition • First Printing
Part No. 133409