Paramount Fitness Ultra UV2 Replacement Instructions Manual page 6

CONFIGURATION 2: 2 BALLASTS INSTALL
Populate the output side of the new ballast with the correct lamp connector harness wires: Connect all
the color wires to the corresponding color inputs in the ballasts.
Please note that the side terminal, not back side terminal, should be used.
H
2 Lamp unit
You will need to use some of the additional
wires included with the kit.
1. Install the supplied double white wire (A)
to the terminal block. Tuck wires behind
terminal block.
3. Install both green ground wires (D), connect
it to the right ground post. Make sure the flat
washer is underneath the ring terminal of the
green wire.
5. Attach the lamp connector harness(es) to the lamp wires.
6. Install the bonnet with the 3 screws.
7. Turn on power to the UV unit and pump & test for system functionality.
C
H
A
F
D
2. Connect both supplied short black wires (F)
to the "Y" connector.
4. Connect all the color wires to the
corresponding color inputs in the ballasts.
6
1 Lamp unit
G