Download Print this page

Paramount Fitness Ultra UV2 Replacement Instructions Manual

Ultimate water sanitizer. tank replacement.
Hide thumbs Also See for Ultra UV2:

Advertisement

Quick Links

Signal Words and Symbols Used In This Manual
This installation guide contains specific precautions and symbols to identify safety-related information. You
will find DANGER, CAUTION, WARNING and NOTICE symbols which require special attention. Please
read them carefully and follow these precautions as indicated! They will explain how to avoid hazards that
may endanger you or persons using or maintaining your pool or spa.
DANGER
avoided, will result in death or serious injury.
CAUTION
could result in minor or moderate injury.
PLEASE REVIEW THE INSTALLATION GUIDE IN ITS ENTIRETY AND HEED ALL SAFETY
INFORMATION. Failure to follow these instructions and warnings can result in DEATH OR SERIOUS
INJURY.
DANGER
When using this electrical equipment, basic safety precautions should always be followed, including the following:
WARNING:
• Follow all applicable electrical codes.
• Turn off power at main source before making any electrical connections or servicing the unit.
• To reduce the risk of electric shock, injury or death disconnect unit from power supply
• Follow the instructions or risk of serious injury or death could occur!
WARNING
eyes and skin. Never look directly at a UV lamp that is connected to a power source. Avoid UV skin
exposure at all times.
295 East Corporate Place • Suite 100 • Chandler, AZ 85225
Toll Free: 1.800.621.5886 • Phone: 480.893.7607 • Fax: 480.753.3397
Paramount@1Paramount.com • www.1Paramount.com
004-027-8707-00
DANGER indicates a
hazardous situation which, if not
CAUTION indicates a hazardous
situation which, if not avoided,
IMPORTANT SAFETY INSTRUCTIONS: READ COMPLETELY
BEFORE PROCEEDING.
UV EXPOSURE & PROTECTION:
UV-A and UV-B radiation can have adverse short and long term effects on the
REV 01
ECN 1685
Tank Replacement Instructions
WARNING
result in death or serious injury.
NOTICE
Pool, Spa & Pond
Water Sanitizer 4BJ1
Publish date 01/30/19
WARNING indicates a hazardous
situation which, if not avoided, could
NOTICE is used to address
practices not related to
physical injury.
EPA Registered
#084221-AZ-001

Advertisement

loading
Need help?

Need help?

Do you have a question about the Ultra UV2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Paramount Fitness Ultra UV2

  • Page 1 Tank Replacement Instructions Signal Words and Symbols Used In This Manual This installation guide contains specific precautions and symbols to identify safety-related information. You will find DANGER, CAUTION, WARNING and NOTICE symbols which require special attention. Please read them carefully and follow these precautions as indicated! They will explain how to avoid hazards that may endanger you or persons using or maintaining your pool or spa.
  • Page 2: Important Notes

    Turn off the power supply to the old Ultra UV2 unit. Turn off power to the pool pump. DANGER Disconnect the input power to the installed Ultra UV2: • For 120v units unplug the supply cord from the GFCI. • For 230v units disconnect the incoming power wires & conduit.
  • Page 3 Before removing lamps you must wear protective rubber gloves and safety eye wear. WARNING Do not handle a hot lamp or serious burns will occur. IDENTIFY YOUR ULTRA UV2 UNIT AND FOLLOW INSTRUCTIONS ACCORDINGLY ULTRA UV CONFIGURATION 1 ULTRA UV CONFIGURATION 2 (see page 4)
  • Page 4 ULTRA UV2 CONFIGURATION 2 Remove retaining clip 1. The lamp array is held in place by an 2. Squeeze the ends of the retaining clip aluminum cup. to remove. 3. Disconnect all lamps by pressing the 4. Carefully lift the lamp assembly from the...
  • Page 5 SINGLE BALLAST WIRING Connect the color wires to the corresponding color inputs in the ballast. TWO BALLASTS WIRING You will need to use some of the additional wires included with the kit. 1. Remove the pre-wired single white wire (E) from the left side of the terminal block.
  • Page 6 Reattach the nut. 4. Reinstall the Bonnet. 5. Turn on the breaker for the Ultra UV2 unit. 6. Power on the pump and ensure the system is functional. • If not functional test the unit per a typical...
  • Page 7 ULTRA UV TANK REPLACEMENT PART NUMBERS Paramount Part# Description 005-422-3100-00 Ultra UV Tank Replacement - 230V Includes: Wires, “Y” connector, quartz tube, quartz tube o-ring, compression washer, 2" union kit, (6) blanking plugs 005-422-3000-00 Ultra UV Tank Replacement - 120V Includes: Wires, “Y”...