Step 4 - Using The Usb1 Interface With A Computer; Compatibility; Setting The Usb Audio Class; Loading The Windows Driver For Usb Class 2 - DCS Bartok User Manual

dCS Bart DAC User Manual
ók
STEP 4 – Using the USB1 interface with a computer
If you do not want to use a computer, you can miss out this step.

Compatibility

The USB1 interface can be connected to Windows™ 10, Windows™ 8.1, Windows™ 7 (SP1), Mac™
OSX (10.5.4 or later) PCs or a sound server, running software to stream PCM data.
The interface should work with Linux Ubuntu servers and computers fitted with USB 2.0 interfaces that
natively support USB Audio Class 1 or Class 2 operation, but this has not been extensively tested.

Setting the USB Audio Class

There are two USB Audio classes, one of which must be set during system set-up. The DAC is
shipped set to USB Audio Class 2.
USB Audio Class 1: The interface operates without a special driver at up to 96kS/s.
To select Class 1, open the menu, navigate to the
The button sequence is:
button to select the
USB Audio Class 2: The interface operates at up to 384kS/s (including DSD/128 over PCM).
For Mac OSX, version 10.6.3 or later is required.
Windows 10 Creator's Edition supports Class 2 operation.
For earlier version of Windows, the dCS USB Class 2 Driver 2018 must be installed onto the
computer before use (see below).
To select Class 2, open the menu, navigate to the
The button sequence is:
button to select the
If an older version of the dCS USB Class 2 driver is installed on your Windows PC,
please un-install it and install the current version.

Loading the Windows driver for USB Class 2

• If ASIO4ALL or any other ASIO driver (e.g. for a sound card) is loaded on your computer, please
uninstall it - otherwise the dCS driver will not work correctly.
• Make sure the DAC is set to USB Class 2 - otherwise the driver installation will fail.
• Power up the DAC and the computer.
• Connect the DAC's
• Go to http://dcsltd.co.uk/products/bartok-DAC/, click the Support link and download the dCS USB
Audio Class 2 Driver 2018.
• Unzip the file to a temporary directory and run the file.
• Follow the on-screen prompts.
• Wait until installation is complete, then re-start the computer.
If you connect the DAC set for USB Audio Class 2 to a Windows computer without first
!
loading the driver, the interface will not operate.
Bartok DAC Manual v1_0x
Menu, ►, ►, Menu, ◄, ◄, ◄, ◄, ◄
Class 1 icon.
Menu, ►, ►, Menu, ◄, ◄, ◄, ◄, ◄
Class 2 icon.
USB1 port to the computer's USB port.
Unit Settings > USB Class
Unit Settings > USB Class
Page 22
Software Issue 1.0x
February 2019
menu page.
and then use the Menu
menu page.
and then use the Menu
English version