Selecting The Bartók Dac As Your Audio Output Device - DCS Bartok User Manual

dCS Bart DAC User Manual
ók
Selecting the Bartók DAC as your Audio Output device
Whichever program you are using to play your music, your computer may not automatically select the
Bartók DAC as the preferred playback device. Once you have connected the DAC and switched it on,
you can correct this as follows:
Mac OSX TM - Open Finder, click on the
dCS Bartok DAC USB ...
device for sound output" from the drop down list. Set the
Integer. Close Audio MIDI
Windows 10 TM / Windows 8.1
Playback panel, right-click
Device. Click the Enhancements
tab, choose 24 bit, 384000 Hz (Studio Quality)
Exclusive Mode, click
Open your streaming program, select the
some music.
If the USB1
USB firmware has been corrupted. This can happen if the USB connection is not secure
while playing a track. Disconnect the USB cable, change the
setting, then change it back and re-connect the USB cable. This will usually solve the
problem.
Bartok DAC Manual v1_0x
Go
from the list on the left-hand side, right-click on it, and choose
Setup.
TM / Windows 7
dCS Bartok DAC Audio
tab and check
OK and OK again to close the
Bartok DAC
input stops responding and cannot be found by the PC, it may be that the
tab and select Utilities
Format
TM - Go to Start >
and choose Set as Default Communication
Disable all enhancements. Select the
from the drop-down box. Check the 2 boxes under
Sound panel.
in the Options
Page 24
Software Issue 1.0x
February 2019
> Audio MIDI Setup.
to 384000.0Hz and
Control Panel > Sound. In the
Advanced
or Preferences panel and play
Unit Settings > USB Class
English version
Select
"Use this
2ch-24bit