Using The Menu - DCS Bartok User Manual

dCS Bart DAC User Manual
ók
Signal Channel
►
Generator Check
Outputs tone
on L channel
only then R
channel only.

Using the Menu

The menu gives the user access to a range of additional features. It also allows new features and
performance enhancements to be added later by software updates.
The menu is controlled by four buttons.
• Press the
Menu button to open the menu or select a setting.
• Press the
► button to page forward through the menu.
• Press the
◄ button to page backward through the menu.
• Press the
Power button to close the menu. Most menu pages close after about 7 seconds.
• While the DAC's menu is open, the Rotary Control pages forwards or backwards.
Use the Menu Guide sheet to help you find the right menu page.
There are six top-level menu pages:
The INFORMATION
contact details.
The AUDIO SETTINGS
accessible from the front panel.
The UNIT SETTINGS
The CONFIGURATION
setup and reset the unit.
The DISPLAY SETTINGS
The SIGNAL GENERATOR
Use the ► button to move the blue highlight to the menu you want, then press the
select it. The next menu level down is displayed. Use the
page you want, then press the
Select the return icon to go back to the previous menu level.
Bartok DAC Manual v1_0x
Phase
► ►
Burn In
Check
Outputs
Outputs noise
modulated pink
on both
noise to burn-
channels then
in your
inverts R.
system.
Figure 10 – The menu sequence
menu gives unit set-up details, software issues, serial number and
menu allows you to set some features that are not directly
menu sets up the unit to suit your system.
menu allows you to lock important settings, save a standard
menu is used to adjust the display.
menu contains test and set-up routines.
Menu button to display the information or change the setting.
► button to move the highlight to the menu
Page 39
Software Issue 1.0x
February 2019
Menu button to
English version