Table of Contents
Advertisement
The system may also require an oiler. Just define an output, set the time run time of the oiler, and the time between
cycles. In the example below the oiler is attached to output 6. It is turned on for 10 seconds every 1 minute. The
spindle has to be on for the oiler to turn on.
Figure 64 Oiler
Figure 65 Cycle Start
Now whenever Input4 is active, E-Stop will be flagged.
Figure 66 - MachMotion Plugin, User Defined Messages
The User Messages can be configured to have custom messages displayed. Each input will do a specific function (E-
Stop, feed hold, stop) and write to the status bar except the No Action option. The No Action just displays the message
on the status bar whenever the input is active. In the example below, when OEM trigger 4 is activated, the message
"MCR Reset!" will be displayed on the status bar.
Advertisement
Table of Contents
