Table of Contents
Advertisement
1.2 Tools Required
Before operating the Apollo I, you must have the following items:
24VDC Power Supply
Computer with Two Parallel Ports
Mach3 Software
If you purchased a CNC control from MachMotion, you already have all of the above items.
1.3 Specifications
Below are the specifications for the Apollo I Breakout Board.
Item
Input Power
Max Power Consumption
Axes
Step and Direction Axis Control
Connection
Max Pulse Speed
Spindle
Relay Outputs
Analog Signal
Outputs
Voltage
Max Current
Commons
Inputs
Voltage
Min Current
Isolated
Enable Circuit
Hardware Enable
Drive Enable
Emergency Stop Circuit
Dimensions
Table 1 Apollo I Specifications
*Only 24V is provided on the breakout board. Any other voltage must be supplied.
**Commons must be supplied externally. If the commons are using the Apollo I power supply, each output can only
source 125mA.
Specification
24VDC
48W
6
5V Single Ended and Differential
RJ45 Connectors and Terminal Blocks
45 kHz
1
Clockwise (CW) and Counterclockwise (CCW)
0-10VDC
8
7V-48VDC*
250mA**
2
9 (Sinking or Sourcing)
2.5V-48VDC
2mA
Optional
2
Relay Contacts, 5V Enable, 24V Enable
Relay Contacts
Normally Closed Connection
8.32"(L) X 5.75"(W) X 2"(H)
Advertisement
Table of Contents
