Table of Contents
Advertisement
To use an output, connect the corresponding common to your voltage source. For standard operation you can jumper
the commons to 24V on the Apollo I. Then connect your signal to the output. See the figure below.
Figure 60 Standard 24V 125mA Outputs
For custom circuits you can provide your own voltages for the commons. In the example below, two separate power
supplies are used. Notice that since the power is supplied externally, each output can draw up to 250mA.
Figure 61 Custom 250mA Outputs
8.2 Configuring Your Outputs
To configure an output, follow the procedure below.
1. On the menu bar click on Config, then Ports and Pins.
2. Select the Output Signals tab. Scroll down to the desired output. There are 20 outputs that you can use.
Advertisement
Table of Contents
