Table of Contents
Advertisement
MultiModem rCell Intelligent Wireless Router
Configure the Ethernet Interface
Using the Web Management Software
You are now ready to configure the Ethernet interface. This is
accomplished by using the router's factory-installed Web
Management software. The software is accessed through a Web
Browser.
1.
From the pc, open a Web Browser.
Type the default Gateway Address: http://192.168.2.1
2. Login
After entering the Address, the Login screen displays.
●
Type the default User name: admin (all lower-case).
●
Type the default password: admin (all lower-case).
User Name and Password Note:
Password are case-sensitive (both must be typed in lower-
case). A password can be up to 60 characters. If Windows
displays the AutoComplete screen, you may want to click No
to tell the Windows OS not to remember the password; this
helps maintain PC security.
Password Caution:
default password to better protect the security of your router.
Use a safe password! Your first name spelled backwards is
not a sufficiently safe password; a password such as xfT35$4
is better.
●
Click the Login button. The Web Management Home
screen displays.
4. Use the Setup Wizard for Quick Configuration
A quick way to configure the modem is to use the Wizard
Setup in the Web Management software.
●
To begin configuration, click the Wizard Setup button
located under the menu bar.
●
After clicking the Wizard Setup button, the Wizard Setup
screen displays.
The Setup Wizard Screen
The following is a screen shot of the Setup Wizard. Using this
screen saves you time so that you are not entering the same
12
It is recommended that you change the
Multi-Tech Systems, Inc. Quick Start Guide
The User name and
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiModem rCell MTCBA-Xx-EN2 Series and is the answer not in the manual?