Table of Contents
Advertisement
Screw-on the power lead from the power supply module into
the power connection on the router. Now, plug the power
supply into your power source.
For Optional Direct DC Power
•
Screw-on the DC power cable into the power connector on the
router.
•
Then attach the two wires at the other end of the DC power
cable to a DC fuse/terminal block on a vehicle in which you
are mounting the MultiRouter.
•
Connect red wire to the "+" (positive) terminal and black wire
to the "–" (negative) terminal. Be sure the GND connection is
correct.
Warning:
Over-voltage protection is provided on the device. To
ensure complete protection, you may want to add additional
filtering to the DC input.
Note:
For automotive application: according to the type of
application, you can use permanent "+" or key-switched "+"
source. Connect the power supply to its source (for example,
in a mobile situation, to the vehicle's DC fuse/terminal block).
Notes
● The
POWER LED.
● The
Reset Button.
5 seconds will restore all factory default settings. It also will set
the username and password back to admin and admin as well
as setting the IP address to the default of 192.168.2.1.
Set Your PC's TCP/IP Address for
Ethernet Functionality
The following directions establish a TCP/IP connection at the pc so
the PC can communicate with the
router. The following directions were written using a Windows XP/
2003+ operating system.
Multi-Tech Systems, Inc. Quick Start Guide
MultiModem rCell Intelligent Wireless Router
The
POWER
Pressing and holding the
LED lights after power-up.
Reset
button for
7
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiModem rCell MTCBA-Xx-EN2 Series and is the answer not in the manual?