At Command For Verifying Signal Strength - Multitech MultiModem rCell MTCBA-Xx-EN2 Series Quick Start Manual

MultiModem rCell Intelligent Wireless Router
Note:
● Select Use the following DNS server addresses.
●
●
● Close the Local Area Properties screen by clicking
● Close the Control Panel.
●
Repeat these steps for each PC on your network.

AT Command for Verifying Signal Strength

To communicate directly with the cellular modem to verify signal
strength, network registeration, and roaming status, telnet to the
modem.
1. To Telnet to the modem. You can access the modem thru the
Run icon or from the Command Prompt:
Click Start I Run icon. In the Open window, enter cmd and
then press ENTER.
Click Start I All Programs I Accessories I Command
Prompt
● In the command window, type telnet 192.168.2.1 5000
● At the Login prompt, type the default user name: admin
(all lower-case). Press ENTER
● At the Password prompt, type the default pass word:
admin (all lower-case). Press ENTER
2. In the command window, type AT+CSQ
3. The router responds with the received signal strength (rssi)
and the channel bit error rate (ber).
10
The pc settings must be in the same subnet range
as the router.
The factory default settings for the router are:
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.2.2
Enter the IP Address for the Preferred DNS Server.
Example: 205.171.3.65
Click OK.
OK.
Multi-Tech Systems, Inc. Quick Start Guide
or