Erasing Configuration; Running Diagnostic Utilities - NETGEAR CG814W Reference Manual

Reference Manual for the Model CG814W Wireless Cable Modem Gateway

Erasing Configuration

The configuration settings of the CG814W Gateway are stored in a configuration file in the
gateway. This file can be reverted to factory default settings. The procedures below explain how to
do these tasks.
It is sometimes desirable to restore the gateway to the factory default settings. This can be done by
using the Erase function.
To erase the configuration, from the Main Menu, under Maintenance select Set Password.
1.
Select Yes for Restore Factory Defaults and click Apply.
The gateway will then reboot automatically.
2.
After an erase, the gateway's password will be password, the LAN IP address will be
192.168.0.1, and the router's DHCP client will be enabled.
Note: To restore the factory default configuration settings without knowing the login password or
IP address, you must use the Default Reset button on the rear panel of the gateway.
Using a paper clip, depress and hold the Default Reset Button. All the numbered Ethernet
1.
LEDs will illuminate green.
Continue to depress the button for at least 5 seconds.
2.
The gateway will reboot and clear its configuration information.
3.

Running Diagnostic Utilities

The CG814W Gateway has a diagnostics feature. You can use the diagnostics menu to test
connectivity to PC using the Ping command:
5-8 Managing Your Network