Installation Manual
20002346
3.3
Connect the 9-wire cable
Procedure
1. Prepare and install the cable according to the instructions in the Micro Motion 9-Wire
2. Insert the stripped ends of the individual wires into the terminal blocks of the
3. Match the wires color for color. For wiring at the transmitter or remote core
4. Tighten the screws to hold the wires in place.
5. Ensure integrity of gaskets, then tightly close and seal the junction box cover and all
6. Refer to the transmitter installation manual for signal and power wiring
Installation Manual
Flowmeter Cable Preparation and Installation Guide.
junction box. Ensure that no bare wires remain exposed.
processor, refer to the transmitter documentation.
housing covers.
instructions.
Transmitter power and I/O wiring
January 2019
17