Zte ZXSDR R8119 Hardware Installation page 17

Component
Wall-mount fixture
ST4.2 × 19 countersunk
self-tapping screws
ST4.2 × 32 countersunk
self-tapping screws
φ6×30 Expansion pipe
Steps
1. Drill holes in the ceiling.
a. Make marks on the cement ceiling in accordance with the holes of the wall-mount
fixture to determine the locations of the holes to be drilled.
b. Use an electric hammer drill to make three holes in the cement ceiling in
accordance with the marks made on the cement ceiling. The holes must be at
least 35 mm deep.
After the holes are drilled, clear the dust by using a dust collector.
2. Hammer expansion pipes into the holes in the ceiling by using a rubber hammer, see
Figure
SJ-20150805085318-002|2016-08-18 (R1.3)
Quantity
1
2
3
3
Note:
2-10.
Chapter 2 Installing the ZXSDR R8119
Overview
2-9
ZTE Proprietary and Confidential