Troubleshooting; Rohs (Restriction Of Hazardous Substances); Manufacturer's Warranty - Hilti SD 6000 Operating Instructions Manual

• After cleaning and maintenance, refit all guards or protective devices and check that they function
correctly.
7

Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem
by yourself, please contact Hilti Service.
Trouble or fault
The screwdriver doesn't work
and all four LEDs blink.
The control switch can't be
pressed, i.e. the switch is
locked.
The screwdriver runs but the
screw can't be driven.
The screwdriver gets very
hot.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9

RoHS (Restriction of Hazardous Substances)

Click on the link to go to the table of hazardous substances: qr.hilti.com/r3008 for the SD 2500.
Click on the link to go to the table of hazardous substances: qr.hilti.com/r5390 for the SD 5000.
Click on the link to go to the table of hazardous substances: qr.hilti.com/r5241 for the SD 6000.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12 English
Printed: 22.10.2018 | Doc-Nr: PUB / 5135921 / 000 / 02
Possible cause
The overload cut-out has been
activated.
The safety lock is engaged.
The wrong direction of rotation is
set.
Electrical fault
The screwdriver has been over-
loaded by exceeding its application
limits.
Action to be taken
▶ Release the control switch and
then press it again. Reduce the
load on the tool.
▶ Set the forward / reverse
selector switch to forward or
reverse rotation.
▶ Use the forward / reverse
selector switch to set the right
direction of rotation.
▶ Switch off the screwdriver
immediately and contact Hilti
Service.
▶ Select a screwdriver with
adequate performance for the
application.