Hilti SD 6000 Operating Instructions Manual page 12

5.2 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.3 Types of work
Observe the safety instructions and warnings in this documentation and on the product.
5.3.1 Driving screws
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable and,
at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Set the screwdriver to forward rotation.
2. Position the screw on the bit and bring the tip of the screw into contact with the working surface.
The optimum screwdriving depth can be set by turning the depth gauge.
3. Use the control switch to regulate the speed of the screwdriver.
5.3.2 Removing screws
1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
3. Insert the bit in the head of the screw and use the control switch to regulate the speed of the screwdriver.
4. Refit the depth gauge after removing the screws.
10 English
Printed: 22.10.2018 | Doc-Nr: PUB / 5135921 / 000 / 02