Care And Maintenance - Hilti SD 6000 Operating Instructions Manual

5.3.3 Switching on in sustained operating mode
▶ Switch on in sustained operating mode.
5.3.4 Switching off after sustained operation
▶ Press the control switch.
◁ The lockbutton returns to its original position.
5.3.5 Screwdriver / depth gauge interface
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Pull the depth gauge forward, away from the power tool.
With the drive spindle exposed in this way, the following operations can be carried out:
Removing screws (set to reverse rotation),
changing bits,
changing bit holders,
changing to magazine operation,
redriving screws.
6

Care and maintenance

6.1 Care and maintenance
WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the tool if signs of damage are found or if parts malfunction. Have the tool repaired by
Hilti Service immediately.
Printed: 22.10.2018 | Doc-Nr: PUB / 5135921 / 000 / 02
English 11