Attaching The Hoop; Removing The Hoop - Husqvarna Viking Platinum MN 1000 User Manual

ATTACHING THE HOOP

If the hoop is not correctly attached, it may affect the
presser foot, damage the embroidery machine or it can
cause personal injury.
Before attaching the hoop, make sure there is sufficient
thread inside of the bobbin.
• Align the left and right side by pushing both sides in
simultaneously until the embroidery hoop locks in
place.
• Insert the embroidery hoop into the flat hoop support
(1).
• Push both sides of the hoop simultaneously into the
flat hoop support until it clicks in place.
• Make sure that the notch of the embroidery hoop
connects securely to the dowels on the flat hoop
support (2).

REMOVING THE HOOP

• Hold around the hoop and flat hoop support as
illustrated.
• At the same time, push the levers of the flat hoop
support down and the hoop upwards.
• Pull the hoop towards you and remove it from the flat
hoop support.
22 – PREPARATIONS
2
1